Motor Mounts?

[Shepp1691]

Where have u gotten them from, my passenger side is sagging like crazy. I was looking at these Mustang Urethane Motor Mounts - 4.6L (96-04) at AmericanMuscle.com 2157883 - Free Shipping!

 

[soccerman002]

For a street car, I'd just go with OEM replacements.

I swapped in a new set on my '99 two years ago when I was putting in a lightweight k-member.

 

[99Cobra_vert]

I have the urethane mounts on mine. I think I ordered them from Late Model Restoration.

 

[Blown2v5.0]

I'll be running the upr solid mounts with polyurethane trans mount to deaden some of vibration from the solids. Never have to replace them again...I hope:coolman:

 

[01RedBeardCobra]

Don't go to autozone. Lol learned that lesson.

 

[shurur]

The ones at AM and LMR look like Energy Suspension.
Energy Suspension motor mounts seem to sit the best for most folks.

The Prothanes sit a little high for some folks but are stiffer.

You should get the complete set and just do the transmission mount as well.

The motor mounts should be the stiffest in comparison to the transmission.

There are quite a few threads on this out there.
I've been lucky so far...I'm waiting until I do headers...

summit, jegs, ebay

 

[kevin01cobra]

ATTENTION
The Urethane motor mounts from AM are great but you will need to ground down the passenger side mount to fit as seen below. Or maybe my stock block was poorly cast....

 

[2000 gt]

solid motor mounts ftw lmao

 

[99Cobra_vert]

ATTENTION
The Urethane motor mounts from AM are great but you will need to ground down the passenger side mount to fit as seen below.

No, definitely not just you. I had to slightly grind some material away, too.