Minimum Requirements for 600 HP!

golfprowanabe

New Member
Established Member
Joined
Jul 13, 2003
Messages
758
Location
Tampa
Ok everyone, tell me what you think is the easiest or least expensive way to obtain 600 HP! Tell us all exactly the parts/mods needed. I figure that the kenny bell is a great way, but is it the least expensive? What are the supporting mods needed for the bell?
 

99stanger

RPB
Established Member
Joined
May 24, 2006
Messages
2,801
Location
Worcester, Ma
Ok everyone, tell me what you think is the easiest or least expensive way to obtain 600 HP! Tell us all exactly the parts/mods needed. I figure that the kenny bell is a great way, but is it the least expensive? What are the supporting mods needed for the bell?

Depending on if your talking about 600whp or 600 at the crank... either way its still going to be about the same price. You will need 60lb injectors, a maf upgrade and a bap... that should run you about 700-800$. Now you can always step it up and go with duel GT pumps and a sct maf upgrade rather than the mafia, but look to spend a little bit more cash. Then your going to need the tune, about 125- 525... depending on if you already have a tuner for the car. Cooling mods should be considered i.e. heat extractor, bigger reservior, head cooling mod all of that will run you about 600$. So assuming you bought all this stuff new and went with say a whipple (which tends to be a bit cheaper than a KB), look to spend at the very least 4,500$ and thats if you can get a good deal from tousley. If not add another couple hundred on that final price.


-Oh don't forget the clutch to hold the power and the back up halfshafts!!
 

Silverboost

Well-Known Member
Established Member
Joined
Apr 27, 2004
Messages
2,222
Location
Fort Mill, SC
use the search button and you will find all the info you need. There is a lot of us running around here with 600+ rwhp.
 

Grey03Cobra

Active Member
Established Member
Joined
Mar 21, 2003
Messages
1,666
Location
San Antonio, Texas
I remember when I had 600rwhp:burnout:

If you want to do it right:

60# injectors
BAP (or better yet, GT fuel pumps)
KB or Whipple SC
SCT 2400
Tune

That will get you to 600rwhp. However, you should also consider the following:

Better clutch is good insurance with good aftermarket quadrant
Drive shaft safety loop
cooling mod
Better Aftercooler
Suspension upgrades (I have Kenny Brown Extreme Matrix)
Rear Diff Brace
Better brakes are a good idea too
 
Last edited:

04cobra13

Active Member
Established Member
Joined
Feb 19, 2007
Messages
3,806
Location
rowland hts
I remember when I had 600rwhp:burnout:

If you want to do it right:

60# injectors
BAP (or better yet, GT fuel pumps)
KB or Whipple SC
SCT 2400
Tune

That will get you to 600rwhp. However, you should also consider the following:

Better clutch is good insurance with good aftermarket quadrant
Drive shaft safety loop
cooling mod
Better Aftercooler
Suspension upgrades (I have Kenny Brown Extreme Matrix)
Rear Diff Brace
Better brakes are a good idea too

+1, thats exactly what you need to do!
 

divided

New Member
Established Member
Joined
Jun 27, 2007
Messages
3,449
Location
San Diego
I remember when I had 600rwhp:burnout:

If you want to do it right:

60# injectors
BAP (or better yet, GT fuel pumps)
KB or Whipple SC
SCT 2400
Tune

That will get you to 600rwhp. However, you should also consider the following:

Better clutch is good insurance with good aftermarket quadrant
Drive shaft safety loop
cooling mod
Better Aftercooler
Suspension upgrades (I have Kenny Brown Extreme Matrix)
Rear Diff Brace
Better brakes are a good idea too


QFT. This is the route I would follow.
 

Users who are viewing this thread



Top