Hey guys, installing the four piece metco pulley kit. According to the instructions, I'm supposed to route the coolant sensor wire OVER the pipe (pic below as I understand what they're saying). With the limited slack on that wire, I just don't see how this is possible and opted to go behind the pipe bracket. Anyone have issues with that? Seems it could be a bit of a pinch point, but I don't see how it goes over.
Metco snub pulley install - question about sensor wire routing
- Thread starter Live Wire
- Start date
I don't see anything wrong with the way you routed it as long as it's free and not being pinched. I routed mine between the crossover and the Metco idler bracket. It's a tight fit but the wire is still free to move.
Users who are viewing this thread
