Anyone know the measurement of the stock driveshaft lenghth that PST needs to make my driveshaft ? 2009 gt500 with pro kit lowering springs....appreciate any help on this...:??:
measurements for new pst c/f driveshaft
- Thread starter kwj1966
- Start date
I'm sure someone has a measurement to give you but it would be your best bet to measure your own car. They should all be close but yours may be a little bit different. Sometimes a 1/4 to 1/2 inch makes a big difference.
GT500 PST Carbon Fiber Driveshaft Install - Page 4 - Shelby GT500 Modifications and Tech. - Team Shelby - Page 4
Post #76 by Justin at VMP Tuning. I never measured mine and just went with what Justin had been ordering for all his previous GT500 orders. Been a couple years now and no problems with it.
Post #76 by Justin at VMP Tuning. I never measured mine and just went with what Justin had been ordering for all his previous GT500 orders. Been a couple years now and no problems with it.
problem is i dont know where to measure from.....is that big counter weight on the trans come off or what? also where is the measuring point on the rearend?
thanks for the info guys....got it figured out . 51 inches....
Thanks guys for the info...... 51 inches , got it figured out
Users who are viewing this thread
