lowered mach, eibach springs, rear passenger side is 1/2" higher??

[built54]

I put the Eibach pro kit lowering springs on my car tonight, and it dropped the front perfectly level side to side, and the rear only went down about 1/4", but the pass side is 1/2" higher than the drivers side. I swapped springs side to side, and the pass side is still higher, i put the stock springs back in and its STILL 1/2" higher... is this normal?? can someone measuer the rear of their mach?

 

[SFVBlueMach]

are you on a uneven surface?

 

[built54]

are you on a uneven surface?

No....

 

[32v Mach1]

maybe you have a bad shock on the driver side

 

[Roots-type]

This is the same on almost all new edge mustangs from six cylinders all the way to the irs cobras. There's nothing wrong with your car.

Pull a rubber and it'll get it close.

 

[Socal Mach]

Mine were within a 1/4" after I got some lowering springs. Check the spring positioning and the isolators, they should be orientated the same. You're also going to have to let the car re-settle.

 

[built54]

i measured today, its within 1/16" of an inch now. good to go!

 

[Socal Mach]

Patience young grasshopper.:beer:

 

[03machme]

yep it will even out after it settles after some driving so just relax lol