Looking for kenne bell powerband rpm

[musclemustang65]

Any guys with a built motor(mine is 2V) and ported heads/cams running a KB? Im about to start a build but im not sure where peak power will come in and with my blower I have to size my pulleys correctly for redline or ill be overspinning it. SO where does your peak HP come in on your setup?

 

[lastmanstanding]

MHS stage 2 heads with MHS stage 1 blower cam. Peek power was at 6300rpm. Mine is 2V as well.

 

[musclemustang65]

Sounds similar to what im looking at. If powerband stays low like that I can go lower on my upper. Otherwise im gonn be within 1,000ish rpm of my max blower at 7,000rpm

 

[lastmanstanding]

I run a 7.75 lower and 2.75 upper and shift at 6500 rpm.