Well my firend L snap the blots for his 6# lower pulley and I was wondering if anyone knew the size bolts they use?? I think they are m10x1.25 just want to make sure.
Little help
- Thread starter 2thedarkside
- Start date
Call one of the SV's
I hate to ask but what is a sv
supporting vendor
cool thanks
for some reason i want to say they are 8mm.
Depends upon whether it's the bolts that go into the balancer for a hub or one piece pulley or if they're for a interchangable pulley type. The bolts are different thread pitch.
use a torque wrench when you install the new ones too. and i dont think a little " anti sieze" would hurt to boot
by the way, are you going to replace the balancer or did you get the rest of the threads out too? good luck.
by the way, are you going to replace the balancer or did you get the rest of the threads out too? good luck.
Users who are viewing this thread
