Lethal return fuel system wiring harness

devilish64

Active Member
Established Member
Joined
Dec 31, 2012
Messages
297
Location
Fremont CA
I've had the division x dual pump fuel system on my car for awhile wich comes with Lethal Performance wiring harness kit that is wired in a way that the fuel pumps run 24/7 when the key is on. Since the day I installed the kit I have had a check engine light wich I have always assumed is caused by the computer not having control of the fuel pumps anymore. Does anyone have a kit like this that they have rewired to not have the check engine light? I am sick of seeing that light on.... Thanks guys! Chad
 

c0rn_fed

Member
Established Member
Joined
Feb 20, 2015
Messages
270
Location
Jersey
That is weird, I have the same kit and no check engine light

Sent from my Pixel XL using Tapatalk
 

devilish64

Active Member
Established Member
Joined
Dec 31, 2012
Messages
297
Location
Fremont CA
When you wired it in did you tap into the violet signal wire or did you just cut it and tie on to it like the lethal directions show?
Screenshot_20170423-165850.png
 

69b302

Active Member
Established Member
Joined
Feb 26, 2007
Messages
511
Location
NY
The FPDM codes are turned off in the tune, when using aftermarket wiring. You can run a Hobbs switch on one of the DivisionX relays, so the second pump only runs when in boost.
 

devilish64

Active Member
Established Member
Joined
Dec 31, 2012
Messages
297
Location
Fremont CA
Oh ok i guess that is my problem..... the tuner I was using must not have been up to speed on what to change in the tune up to turn the CEL off.
 

Users who are viewing this thread



Top