Well i found a set of bbk ceramac L/T headers but the guy had to dent them a llittle bit so they didnt hit part of his car. Will this be a restriction of any kind?
Last edited:
L/T header ?
- Thread starter 19ClearCobra96
- Start date
It's not big enough to disrupt the exhaust flow at that part of the header. Sometimes you have to do a slight bend here or there to make them fit. Of course, if you were to put them on with the engine out that would make things a whole lot easier. :-D
lol, I almost positive that those are the ones on Ebay by the orange pool table that they are on. http://cgi.ebay.com/ebaymotors/ws/e...&item=7962198215&rd=1&sspagename=STRK:MEWA:IT I bought those headers and his X-pipe last night from him for $420 shipped. I also was concerned about the dents, until I heard that tons of people had to do the same thing to get them to fit.
Last edited:
I guess it doesn't matter now since budguy beat you to them. LoL :kaboom: :whine:19ClearCobra96 said:
I just did the same thing about 3 days ago to my headers. If not they just barely touch the k-member, just enough to make a slight tapping sound. I noticed no decrease in power. If you look at the drivers side they also have a slight indentation to clear the steering shaft.
Users who are viewing this thread
