Kenne Bell Pulleys - 12mm bolt / new style

[tmsoko]

I have four pulleys for the new style drive with the 12mm vented bolt.

Three are Kenne Bell - $40/ea shipped
3.0" Used / good condition (I should have hit this with scotch brite before picture. Will be cleaned up before I ship.)
3.625" New in bag
4.0" New in bag

One is a Richard Racing "no slip" - $75 shipped
2.9" New

 

[tmsoko]

Ttt

 

[SVT_Troy]

Would you happen to have a spare pulley bolt and spacer that goes behind the pulleys? Gotta check kb's site to figure out which pulley you have an d if i can use them. I know i wish your richards racing was a 2.7......

 

[tmsoko]

No bolt / spacer. Let me know if these will work for you.

 

[tmsoko]

Ttt

 

[KillaCobra]

So would these fit a 2.2? 8 rib?

 

[memnoch138]

Pm me your paypal. I'll take the 3"

 

[tmsoko]

So would these fit a 2.2? 8 rib?

If it has the larger 12mm vented bolt, yes. Kenne Bell changed on the 2.2L from the 10mm they always used to the 12mm. After that, all the 2.4L, 2.6L, and 2.8L kits used the 12mm.

 

[memnoch138]

$

Payment sent :rockon:

 

[KillaCobra]

Mine is a 10mm, anyway of changing it?

 

[SVT_Troy]

Mine is a 10mm, anyway of changing it?

You have to send it into KB and get them to do the snout upgrade on it. Cost about $400

 

[KillaCobra]

You have to send it into KB and get them to do the snout upgrade on it. Cost about $400

Thanks!

 

[tmsoko]

3" is sold. Others available.