KB Strut Tower Brace Fits which SCs?

[Warp03Cobra]

DOes any body know which superchargers the Kenny Brown Strut Tower Brace fits with?

I know stock works, but what about Kenny Bell (2.6?) or Whipple?

Thanks,
Evan

 

[Warp03Cobra]

ttt
Anybody know if the Kenny Brown Strut Tower Brace clears the KB superchargers or the whipple?

 

[NFCstang]

Can you even find a Kenny Brown since they shut down production?

 

[Warp03Cobra]

I have a new one I am selling on ebay, and I was asked if it will fit with either of the kbs

 

[SVTcobraGirl]

doesnt look like much room between the stock eaton and the KB strut tower brace on mine..

 

[03SBGT]

I can't speak for the K Brown STB but my MM one is going to have to go.

 

[BLK03SVT10TH]

They made a different model STB for the KB

KBP29502 KENNE BELL SUPERCHARGER Strut Tower Brace $ 194.95

off of RPMOutlet.com

 

[GodStang]

I do not think any STB will fit with the new KBs unless you have a new hood.

 

[BLK03SVT10TH]

I do not think any STB will fit with the new KBs unless you have a new hood.

I'm sure your right about that, those were for the old 2.2 I believe.

 

[hawaiiancobra]

there are two different braces, one for eaton, one for kb blower, i have both. kenny brown strut tower brace for a kenne bell is taller and raises up right at the strut tower where as the eaton kenny brown strut tower brace is lower and leaves the strut tower lower at a 30 degree angle. dont know if both are available check here http://www.v8power.com/cat--Mustang-Strut-Tower-Braces--stru.html you'll have to call them to see if they have the brace for the kenne bell. they bought out his shop and parts department

 

[BLK03SVT10TH]

there are two different braces, one for eaton, one for kb blower, i have both. kenny brown strut tower brace for a kenne bell is taller and raises up right at the strut tower where as the eaton kenny brown strut tower brace is lower and leaves the strut tower lower at a 30 degree angle. dont know if both are available check here http://www.v8power.com/cat--Mustang-Strut-Tower-Braces--stru.html you'll have to call them to see if they have the brace for the kenne bell. they bought out his shop and parts department

Do you know if you can run the KB STB on an Eaton equipped car? That might resolve some problems with running aftermarket Intakes and CAI setups that don't fit when using the Eaton STB.