This kit was used on my 2.2L to produce 15.63 PSI. Only 1,000 miles on these pullys. I sent out the KB pully to get a carbinite coating which costed me $90 + the cost of the pully. The 2 idlers allowed for enough belt wrap and with the coating I didn't get any boost drop off and had minimal slip if any.
Easy way to get up there in PSI witout an 8 rib setup.
Retail prices are: Thump 76 $149 90 $159 KB pully $69 Coating $90 Wrench $25 - close to 500 in parts
40% off is a deal -
Price for all: $300.00 Shipped -- TXT ME 630-945-8118
Kit but will seperate:
1 - 2.75" Kenne Bell Pully with a Carbinite Coating
1 - KB pully wrench
1 - 76 mm idler w/ spacer and bolt
1 - 90 mm idler w/ spacer and bolt
Look of it on the car. They are dirty but have no blemishes at all.
Easy way to get up there in PSI witout an 8 rib setup.
Retail prices are: Thump 76 $149 90 $159 KB pully $69 Coating $90 Wrench $25 - close to 500 in parts
40% off is a deal -
Price for all: $300.00 Shipped -- TXT ME 630-945-8118
Kit but will seperate:
1 - 2.75" Kenne Bell Pully with a Carbinite Coating
1 - KB pully wrench
1 - 76 mm idler w/ spacer and bolt
1 - 90 mm idler w/ spacer and bolt
Look of it on the car. They are dirty but have no blemishes at all.
