I installed my QA!1 K Member yesterday but I am a little concerned that I did not use the correct bolt hole on the right side. I used the front hole but there are two holes further back. I am unsure b/c I am doing a clutch at the same time so there was absolutely nothing holding my engine in place except for pole jacks.
K Member Install Question
- Thread starter BIGWHUP03
- Start date
Need more information. Pics would be huge.
OK I will post pictures tomorrow. Another question I have is that I put headers on as well and the steering shaft is touching the header but not on the metal part of the shaft. There is a plastic sleeve on the steering shaft thats touching the header... How important is that sleeve?
Users who are viewing this thread
