K member for Hellion single kit

[Cabbage]

I’m possibly looking at getting rid of my 2.3 tvs and going with a single hellion kit. My question is, has anyone used a Steeda K member with the kit or will it work? If not I’ll sell it and do a MM, no big deal but I have the Steeda new in the box kinda wanted to use it if I could. Also has anyone used JBA shorty headers or custom headers instead of the factory manifolds. I hate the idea of putting them back on the car. Lol
Thanks for the help in advance


Sent from my iPhone using Tapatalk

 

[01yellercobra]

Not apples to apples, but I installed a Hellion kit on a 97 GT. There's a couple pipes that run under the K member by the driver side control arm mount. I think there's a pic of them in the turbo forum. Those would be the pipes I'd be concerned about fitting with the Steeda. If the bends on the Steeda are similar, you should be good.

Yes, you can bolt the kit to the shorty headers. They exit in the same places as factory manifolds. My buddy had FRPP shorties on his car when we did the install.