Cars been in the shop for a month getting the new motor installed and I am finally picking it up at the end of the week. Just curious if any of you might be able to tell me what I should be making since I wont be havign it dynoed until march 1st.
Built motor bored .20 over
headeds shaved and ported .2 (not much of a difference)
bbk long tube headers
bbk x pipe no cats
mafia
kb 2.4
kb boost a pump
kb boost a spark
60 # injectors
afco heat exchanger
spec 3+ cluth
fidanaza flywheel
6# crank
2.9 upper
What do you think I can get out of this set up? A friend of mine had a 2.3 whipple on a stock block and did 650 on pump (vert.) Do you think I would be anywhere close to 700? Or am I kidding myself?
Built motor bored .20 over
headeds shaved and ported .2 (not much of a difference)
bbk long tube headers
bbk x pipe no cats
mafia
kb 2.4
kb boost a pump
kb boost a spark
60 # injectors
afco heat exchanger
spec 3+ cluth
fidanaza flywheel
6# crank
2.9 upper
What do you think I can get out of this set up? A friend of mine had a 2.3 whipple on a stock block and did 650 on pump (vert.) Do you think I would be anywhere close to 700? Or am I kidding myself?
Last edited: