i've had them for a while but haven't installed them yet, anything good to know about installing them? is it a biatch? I did buy that tool for them but not sure how to use it.
IRS bushings?
- Thread starter bobster
- Start date
it is a biatch but worth it.
if you like wheel hop, dont install the bushings. it gets rid of it.
if you like wheel hop, dont install the bushings. it gets rid of it.
It's definately a biatch, and the tool doesn't always work. My stock rubber bushings were not budging, even with a 5 ft. pole on my breaker bar. Only thing that happened was it stripped the threads on the removal tool.
READ THIS WRITE UP on how to remove the stock bushings, it really helps out:
http://svtperformance.com/forums/showthread.php?t=69011
READ THIS WRITE UP on how to remove the stock bushings, it really helps out:
http://svtperformance.com/forums/showthread.php?t=69011
+1 :rockon:
Read the link in my sig if you're doing bushings in an IRS! :read:
:thumbsup::coolman::beer:
+on the grease fittings big time!! it kills most of the squeaking you get from the delrin on metal.
If you don't have Bruce's bushing kit...you should think about getting it.
It's such a royal PITA to change the bushings out in an IRS that you'll only want to do it once. So, use the best parts and opt for the grease fittings. You won't regret this decision. :beer:
I bought the maximum motorsports bushings from letheal with the tool.
Users who are viewing this thread
