Intake manifold bolt

[Baysixx]

While installing the boss intake manifold I over torqued one of the six built in bolts on the intake manifold. When it broke it left a little bit of thread sticking out so I was able to take out the bottom half of the bolt pretty easily. My question is how do I replace the bolt on the boss manifold. They seem to be built into the manifold. I bought a new set of 4 manifold bolts and just need to replace them in the manifold. Thanks in advance.

 

[CPRsm]

I can't quite remember but I think it's a small washer on the underside of the intak that holds the bol in the intake.

 

[try03venom]

Lesson learned now go buy a inch lb torque wrench

 

[Krace]

You can wiggle them out of the manifold. That's what i did, then i used one from the stock manifold to replace it.

 

[Blazer707@TBR]

This^^

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

 

[Baysixx]

You can wiggle them out of the manifold. That's what i did, then i used one from the stock manifold to replace it.

Just did this.

Lesson learned now go buy a inch lb torque wrench

Ya I'm a dumbass and thought it was 89ft/lb not in/lb.