Back in June I did the chip,pulley, and BF TB\plenum from Amazon Racing and everything was fine except we couldnt get a good voltage reading off the TPS. It was either "0" or greater than "3". I've read every thread and tried everything including different voltage meters, paperclips, and angles. I dont know WTF the problem is. I'm not an idiot and this is getting frustrating. The idle is fine and it never goes over 1000rpm but the SES light stays on because of the lack of reading. I dont want the light on for something else and not notice because of this.
I'm taking it in tomorrow for a noise around the trans case and cats and for an oil change. Maybe I'll have the guy set it while doing the oil change. I dont want to watch because I know it'll take 3.2 seconds for him to do it. it seems the easier something is to do the harder it is for me to do it.
Any ideas? Maybe I just suck
I'm taking it in tomorrow for a noise around the trans case and cats and for an oil change. Maybe I'll have the guy set it while doing the oil change. I dont want to watch because I know it'll take 3.2 seconds for him to do it. it seems the easier something is to do the harder it is for me to do it.
Any ideas? Maybe I just suck