Measurements are approximate.
40mm width (outside), 34mm width at the face. 80mm diameter at the face. 17mm hub I.D.
Bearing in it is a NTN 6203LH
This is part of my Paxton SN2000 kit on my 95 Cobra but from what I've gathered the idler and tensioner were OEM ford parts.
And if if that gets me nowhere, recommendations on an OEM replacement (or aftermarket if they're not outrageously priced). I was hoping to stick with a flanged pulley because I may be fighting some belt alignment issues but if I'm forced to go smooth I might be fine. Tried looking at pulleys for Supercoupes and 03-04 Cobras but didn't find anything close yet.
