how much HP and TQ

[1fast97Cobra]

I just got my car back together and have not had a chance to get it dynoed. I am trying to figure out how much power i am putting out. Mods are as follows.

Engine:
4.6l teksid block .020 over
Manley h-beam rods
J.E. SRP 80 8.5.1 pistons
B-heads fully port and polished 3 angle valve job.
SHM Blower cams
Sniper 95mm MAF
42lb green tops
Vortech s-trim blower running about 10lbs boost
Snow meth injection stage 2 kit
Imrc deletes
bbk twin 65mm tb
TRE 255lb fuel pump

Exhaust:
BBK longtube headers
Mac prochamber o/r
flowmaster super 44's

Transmission:
01 Termec t-45
Centerforce dual fiction clutch
FRPP driveshaft
Motive 4.10 gears
F1 lighted flywheel
Steeda tri-ax shifter

I know i am forgetting stuff but here is most of it.

 

[MLS]

Im gonna guess 460-480 to the wheels. Common numbers are 400-440 rwhp with 10 psi on a centrifugal. The 8.5 cr is going to effect your numbers, but the meth will help. Just curious why not run 15 psi or more?

 

[crazycarlo]

im gonna go with 457