I am running the below mods and am only seeing 13lbs of boost. i recently installed the ported blower with the same size 2.93 pulley. looked like it was making about the same boost (11.5-12lbs). It has been 95+ degrees since the 2.76 was installed but still thought i should be at least 14lbs. I'm not seeing boost dropping so i don't think the belt is slipping. I did gain 1lb of boost from the 2.93. Does this sound about right with the heat and free flowing exhaust. No dyno numbers.
Steggy Stage IV
stage II ported T/B
cut/ported/welded plenum
2.76 Billetflow ultra-grip pulley
4 piece idler set
metco tensioner
JTL RAI
1 3/4 full full length headers
O/R x-pipe
steeda/borla catback
Steggy Stage IV
stage II ported T/B
cut/ported/welded plenum
2.76 Billetflow ultra-grip pulley
4 piece idler set
metco tensioner
JTL RAI
1 3/4 full full length headers
O/R x-pipe
steeda/borla catback