Hey guy, do you all think I can run 10's with my combo?

[venmousracer]

You guys think I can run 10's with my current combo, at least a high 10, maybe around the 10.80's-10.90's. Here is my current combo;
suspenson:
subframe connetors
upper and lower control arms
mm panard bar
ford racing c springs
bilistien shocks and struts
AJE k-member and a arms
and spherical housing bushngs
Mods:
99 cobra with 03 cobra motor and tranny
solid axle conversion with 3:73 gear
2.8 pulley
2 100mm idlrs and 1 90mm aux idler
12 inch open end cone filter
C/L maf
SCT chip from Apten
off road x-pipe
Bassani catback
Gords Heat exchanger
and 15x8 inch pro stars rear with et streets and skinnies up front that in drag mode
aluminum cltch cable quadrant kit with firewall adjuster from upr
Ypu think thats enough for a high 10, if not what else. thanx Ed

 

[venmousracer]

anyone???? TTT

 

[Dana]

Yes, that should do it. IF the clutch holds out. Mine didn't.

Good luck.

Dana

 

[SNKBITE]

I think your gonna need a little more boost. However, if weather conditions are perfect and you can get it to hook and get a 1.5 or 1.6 or so 60 foot time, maybe you can do it.
Good luck and let us know what you do.
Marc

 

[venmousracer]

Dana;
what clutch would you reccomend? and also where to get the upgraded input shaft, might as well do it over the winter. Eddie

 

[Dana]

Eddie,
I don't have a recommendation, YET. Ask again in a few months, since I really can't test it out. But...
I did install the CenterForce Dual Friction just last week. I also went with an iron flywheel.
Also the 26 spline input shaft.
CenterForce has a kit specifically for this input shaft conversion now. The part # is DF 148075
Find a local dealer to order the clutch & TOB from.
About $250


Liberty Performance is the source for the input shaft.

Liberty's High-Performance Products
6390 Pelham Road
Taylor, Michigan 48180
(313) 278-4040

With shipping, should be right around $250

Dana

 

[venmousracer]

thanx Dana: one last question, do you think I can use my 99 iron flywheel when i upgrade the unput shaft and clutch? Ed

 

[Dana]

I don't know for sure, but I THINK if you have an 11 inch clutch and 8 hole center, it should work. 99 & UP Cobras had 8 bolt cranks, but I'm not sure about the 11 inch clutch. You could talk to CenterForce to find out for sure, if you plan on ordering their clutch. A guy named Larry is decent to talk to. You could ask him. Everything I can find says that the two should interchange without a problem.

Dana