I have a 04 Cobra with the following mods:
2.76 s/c pulley and 4 idlers
Accufab throttle body and inlet
C&L 95mm mass air flow and true flow tube and cone filter
Dual bypass heat exchanger
h-pipe with high flow cat out to flowmasters
I'm pushing 488rwhp and 526rwtq on a safe tune (only 8000km or 5000 miles on the car)
The question I have is if I put on a 4# crank pulley on is there anything else that I would have to add (injectors, pumps or boost-a-pump, ect). I have a few months before it warms up around here and just wanted to do some buying while the car was off the road.
Thanks for your help in advance.
Ace
2.76 s/c pulley and 4 idlers
Accufab throttle body and inlet
C&L 95mm mass air flow and true flow tube and cone filter
Dual bypass heat exchanger
h-pipe with high flow cat out to flowmasters
I'm pushing 488rwhp and 526rwtq on a safe tune (only 8000km or 5000 miles on the car)
The question I have is if I put on a 4# crank pulley on is there anything else that I would have to add (injectors, pumps or boost-a-pump, ect). I have a few months before it warms up around here and just wanted to do some buying while the car was off the road.
Thanks for your help in advance.
Ace
