I apologize for not having a pic of my dyno to show you why we think it's belt slip.
First off let me tell you my set up. Stegy stage IV, 2.93 billetflow upper with all the idlers(1- 92 mm and 3 - 100mm idlers) and a metco 2lb lower with the idler in the upper position. I have a gates micro v belt 78". I had to notch the tensioner to get it on. We didn't have a mafia at the time of the tune so I realize I could be pegging the maf. The dyno sheet falls off at about 5- 6k it pulls strong and then goes jagged edged at the 5-6k mark. There is all kinds of belt dust on the pulleys'. When I step on it, and get to a bout 4k and let off the gas, it surges as if I didn't know how to drive stick. Also it feels like it wants to grab then it doesn't then it does. It's all over the place. Any suggestions
First off let me tell you my set up. Stegy stage IV, 2.93 billetflow upper with all the idlers(1- 92 mm and 3 - 100mm idlers) and a metco 2lb lower with the idler in the upper position. I have a gates micro v belt 78". I had to notch the tensioner to get it on. We didn't have a mafia at the time of the tune so I realize I could be pegging the maf. The dyno sheet falls off at about 5- 6k it pulls strong and then goes jagged edged at the 5-6k mark. There is all kinds of belt dust on the pulleys'. When I step on it, and get to a bout 4k and let off the gas, it surges as if I didn't know how to drive stick. Also it feels like it wants to grab then it doesn't then it does. It's all over the place. Any suggestions
