I recently pulled the snout off my eaton to replace the front and rear drive shaft bearings. While trying to remove the bolts that hold the snout to the case, I ran into the outlet fitting for the intercooler adaptor. Seems to be a common problem upon searching. To get the snout off, there seem to be two methods: 1) partially remove the intake and lift the blower up to clear the fitting or 2) remove the fitting from the block. I opt'd for option 2 (seemed like less work at the time).
Link 1 - thread about removal of fitting
Link 2 - blower removal steps - good picture on step 9 > red arrow on the right
Now that I have the snout rebuilt and put back on the car, I need to replace this fitting. I think I could clean this one up and reuse it if I HAVE to, but I'd prefer to get another one.
Does anyone know what this piece is called and where to get one?
Link 1 - thread about removal of fitting
Link 2 - blower removal steps - good picture on step 9 > red arrow on the right
Now that I have the snout rebuilt and put back on the car, I need to replace this fitting. I think I could clean this one up and reuse it if I HAVE to, but I'd prefer to get another one.
Does anyone know what this piece is called and where to get one?