Anyone installed injectors on your boss? Any write ups?
Help installing injectors
- Thread starter tek302
- Start date
Remove the Throttle Body (TB). See: Throttle Body\Service and Repair.
Remove the EVAP (Evaporative Emission) canister purge valve. See: Emission Control Systems\Evaporative Emissions System.
Disconnect the vacuum tube from the intake manifold.
Remove the crankcase ventilation tube.
All engines
Position the heater hoses aside.
Remove the 2 nuts and the LH heater hose support.
Position the vacuum tube assembly aside.
Remove the 2 nuts and the RH heater hose support.
Remove the LH and RH fuel rail insulators.
Disconnect the 8 fuel injector electrical connectors.
Disconnect the fuel supply tube.
Remove the 4 fuel rail bolts.
Remove the fuel rail and fuel injectors as an assembly from the intake manifold.
Remove the retaining clips and fuel injectors from the fuel rail.
NOTICE: Do not reuse the O-ring seals. Failure to follow this direction may cause the fuel system to leak.
Remove and discard the fuel injector O-ring seals.
Remove the EVAP (Evaporative Emission) canister purge valve. See: Emission Control Systems\Evaporative Emissions System.
Disconnect the vacuum tube from the intake manifold.
Remove the crankcase ventilation tube.
All engines
Position the heater hoses aside.
Remove the 2 nuts and the LH heater hose support.
Position the vacuum tube assembly aside.
Remove the 2 nuts and the RH heater hose support.
Remove the LH and RH fuel rail insulators.
Disconnect the 8 fuel injector electrical connectors.
Disconnect the fuel supply tube.
Remove the 4 fuel rail bolts.
Remove the fuel rail and fuel injectors as an assembly from the intake manifold.
Remove the retaining clips and fuel injectors from the fuel rail.
NOTICE: Do not reuse the O-ring seals. Failure to follow this direction may cause the fuel system to leak.
Remove and discard the fuel injector O-ring seals.
Awesome right up!!
Users who are viewing this thread
