H&R Race Spring with Bilstein HD's

[Nickrap9]

I just installed my H&R race spring and Bilstein HD's on all four corners (03 Vert). I was wondering for those who are running the same set up, what strut spacers are you using. I also installed Maximum Motorsports C/C plates which included 1/4 and 3/8 spacers. I installed them using the stock ride height specs provided by MM bc the lowered orientation put the strut post too high for hood clearance. Should I have re-used the single stock Bilstein spacer? Any input would be great.

Thanks,

Nick

 

[0-MYSTACHROME-4]

Are you running any ISO's? I put my strut shaft as high as it can go without hitting the hood. After getting an alignment and dialing in some good negative camber the placement of the strut shaft will be in a different location and you will gain some extra clearance between the hood

 

[Nickrap9]

Yeah. I'm running a single lower iso in the front and both top and bottom iso's in the rear.