H&R Race Spring Help

[Termilvr]

So I installed my rear h&r race springs this past weekend and noticed that the coils are pretty close to the chassis. I am a little worried that the spring coil will rub on the chassis when it is compressed. Any suggestions?
Should I not worry about it
Try and re-position the springs
Try and bend the chassis sheet metal out of the way

 

[Termilvr]

Anyone?

 

[b_dike]

Mine don't rub. Never really noticed they were that close though.

 

[White Elephant]

You may have to take something like a 2 lb. sledge or a pry bar & "massage" that area for clearance.

 

[bleedingfordblu]

yeah i just tried to push that lip away for the spring to fit, no biggie

 

[Kyle_KleinSS]

I remember this when I did mine. Which way is the bottom coil facing?

 

[Termilvr]

I remember this when I did mine. Which way is the bottom coil facing?

The end of the coil is lined up with the drain/e brake mount.

 

[Kyle_KleinSS]

Maximum motorsport instructions said this as well. They didnt sit the same in each pocket at the top, which I assumed would make it sit uneven in the back.. So what I did was face the end of the pigtail on the bottom facing the driver side. I did this with both springs. Thats how the gt instructions say to align them. Doing this the springs sit exactly the same height. Just point the bottom end of the coil straight to the driver side and call it good.