Going back to stock cold air intake on 99 svt cobra mustang

[cartec]

I'm trying to go back to the stock air intake after removing what looks to be a home made intake; the home make one's only identifiable words were... Buckhorn Rubber Products.

The car came with a filter box(2ru-9c662-ca) and a xr3u-9r504-bb parts to go back to stock. Both seem to be correct, but when I try to connect the mass airflow tube and sensor there is a visible gap between it and the filter assembly box.

This link shows a couple of pictures showing the gap.

https://goo.gl/photos/

And does anyone know the part number for the connecting hose from the valve cover to the intake?

 

[01yellercobra]

There's a screen that goes there to straighten the air flow over the MAF. I haven't seen on in a long time.

 

[cartec]

Anyone know where I can buy one of those screens?

 

[cartec]

I found this from a parts place in Statham, GA.

 

[devin_svt]

i have the hose you are looking for!!!

 

[286rocks]

Hate to Hijack a thread but does anyone know if the plastic tube part that extends into the fender is the same for GT/V6 models? My car is missing it and I was hoping to find one somewhere fairly easily.

 

[cartec]

I should have mentioned it along with the screen, but I found the hose part too. 286rocks, give mpssalvage a call... They were quite knowledgeable.

 

[98_Undertaker]

Hate to Hijack a thread but does anyone know if the plastic tube part that extends into the fender is the same for GT/V6 models? My car is missing it and I was hoping to find one somewhere fairly easily.

I believe they are all the same