Gap for Denso IT 20 plugs with 6 pound lower pulley?

[brasil]

Should I gap the IT 20's at .35 with a 6 pound lower pulley and stock upper pulley?

 

[brasil]

Anyone running these plugs here with about 12 -14 pounds of boost?

 

[Sonic03inSC]

Anyone running these plugs here with about 12 -14 pounds of boost?

See sig

 

[brasil]

Sonic, I am going to be running a little less boost than a 2.80. WOuld you recommend I gap them at .35 instead of .38? Also, I was under the impression that the IT 22's are needed when running 7 -8 pounds of additional boost?

 

[brasil]

Ttt

 

[Sonic03inSC]

Sonic, I am going to be running a little less boost than a 2.80. WOuld you recommend I gap them at .35 instead of .38? Also, I was under the impression that the IT 22's are needed when running 7 -8 pounds of additional boost?

I see anywhere from 13-15psi when it's cold, so it should be about the same boost.
On a side note, I may give the Brisk plugs a try next month. I've had the Denso's for about a year now 20k miles. I have a low rpm skip or stumble.