FS: Built 4.6 Teksid Short Block

[lee4him]

Fresh 4.6 Teksid block assembled by BlowbyRacing out of Florida. Built to support big turbo hp. Block is ready to go. Asking $2500

- Cobra Crank
- Manley H-beam rods w/2000 bolts
- MaxMod 17cc pistons
- Steel rings
- C77 bearings
- ARP Main Studs
- Bored .020 over

Also have a set of C-heads if interested $500

 

[Wayneo]

What's the compression supposed to be with the 17cc pistons?

 

[lee4him]

Depends on the head but was built for heads which would produce 8.5:1

 

[Tifosi2003GT]

4 or 9 thread 03/04 cobra heads, fully assembled, mileage ( what did they come out of ) ? very intereted

 

[98 Saleen Cobra]

Great looking motor!! Those don't like ARP mainstuds though.. They look like stock bolts???

 

[lee4him]

Heads are not fully assembled, but have all the components including cams.

Was informed by the engine builder they were, but looking at them they don't look like ARP. Will have to double check tomorrow. (Keep in mind, I took ownership of this block when I bought my 03 Cobra from a gentleman in Florida. After I got it home, I contacted BBR and what I have listed above is what they sent me regarding what they had done to the block).

 

[Tifosi2003GT]

4 or 9 thread 03/04 cobra heads, fully assembled, mileage ( what did they come out of ) ? very intereted

I had a few more questions you didn't answer.

 

[lee4him]

Sorry they are 4 thread but I believe are 01 Cobra heads. They are not fully assembled but have all the hardware for assembly. As for mileage, I'm not certain. They were given to me when I bought my 03 cobra a few years back.

 

[JeremyAlan]

still for sale?

 

[lee4him]

Still for sale, but local pickup only.

 

[JeremyAlan]

where are you located sir?

 

[lee4him]

Dayton, Ohio

 

[JeremyAlan]

no hope for shipping? :/

 

[SpittinCobra]

Dayton, Ohio

interested in heads and can pick up. send pics to [email protected]