I've got a brand new/un-used Big Stuff 3 setup, with harness, intake manifold, EFI Spyder elbow, and accufab TB for a SBF.. I recently bought a project car and this came with it. It was never run or installed.
Comes with:
BS3 EFI unit
Complete (labeled) engine harness (plugs into any EFI'd SBF)
Precision Turbo 65lb Injectors
Billet fuel rails
-6an fuel line (connects rails)
-6an fuel line fittings on each rail
MSD Ignition Box
MSD Blaster 2 Coil (used)
EFI Spyder intake manifold/elbow setup
Accufab TB
Polished thermostat housing
Sensor package
TB Cable bracket
Software and instruction sheet from Big Stuff 3
Everything is brand new, except the coil.. but it works perfectly fine. Works with Ford distributor, and all wires are labeled and/or plug and play. Simply plug it in, run the harness, and hook up your power/ground. Basically, a turn-key EFI setup. Over $3500.00 invested in this. Looking to get $1995.00 shipped to your door.
Thanks!
Comes with:
BS3 EFI unit
Complete (labeled) engine harness (plugs into any EFI'd SBF)
Precision Turbo 65lb Injectors
Billet fuel rails
-6an fuel line (connects rails)
-6an fuel line fittings on each rail
MSD Ignition Box
MSD Blaster 2 Coil (used)
EFI Spyder intake manifold/elbow setup
Accufab TB
Polished thermostat housing
Sensor package
TB Cable bracket
Software and instruction sheet from Big Stuff 3
Everything is brand new, except the coil.. but it works perfectly fine. Works with Ford distributor, and all wires are labeled and/or plug and play. Simply plug it in, run the harness, and hook up your power/ground. Basically, a turn-key EFI setup. Over $3500.00 invested in this. Looking to get $1995.00 shipped to your door.
Thanks!