These are practically new. I drove around on them for about 1k miles and I think I made 2 passes on them. Axle tube shifted so I parted the 8.8" and went with a 9". I had them in a fox housing but it was setup to be spaced out to an sn95 width. If you look closely at the bottom axle in the picture you can see how much spline engagement there was. So with that said, these should work in any 8.8 from a fox width up to sn95 and possibly even sn99 width. However, to work in a drum brake fox I would suspect some of the spline would likely need to be cut off.
31 spline, small 9" ends (no C clip groove), long 1/2" studs, 5 lug.
I'd like $200 plus shipping for the axles with bearings, what's left of the axle tubes (salvageable bearing cups/ends and LCA brackets for LCA re-location), and bearing retainers.
31 spline, small 9" ends (no C clip groove), long 1/2" studs, 5 lug.
I'd like $200 plus shipping for the axles with bearings, what's left of the axle tubes (salvageable bearing cups/ends and LCA brackets for LCA re-location), and bearing retainers.
