Guys,
I will be heading overseas in January for an internship and it's time to start tying up some loose ends. First is the extra car parts.
Without time to work on the car, and since i'm going overseas in less then a year i'm going to put off any further mods to the car. I was going for a N/A C-head build. Here are the first round of parts i'm going to let go.
All prices listed are shipped. Local sale would be meet anywhere on I-85 between W-S and Greenville, SC.
03 DOHC Cobra cylinder heads. $825 shipped. ~15k miles. They have 98 Cobra cams installed which make 20+ HP on a Mach 1. Heads are in great shape i had them cleaned and inspected by KT engines in Concord, NC. They were milled from 52cc to 47cc chambers to arrive at a Compression ratio of ~10.7:1. This is a safe limit for pump gas stock bottom end n/a cobras and mach 1's.
04 Mach 1 intake manifold. $350 shipped. SOLD
04 Aviator intake manifold. $300 shipped. Was purchased for my project as phase II of a N/A C-head build up. Complete with rails, injectors, throttle body, IAC, fuel rail pressure sensor, IMRC motor, and throttle and cruise bracket.
http://www.fidanza.com/SteelFlywheels.aspx
Fidanza 8-bolt Billet Steel Flywheel. $150 shipped Has about 15,000 miles on it, but comes with a new friction insert (still in the plastic) so for all practical purposes its new. These retail for $240 i'd like to get $150 shipped. Paypal only please. Pics available tomorrow upon request. For those that dont know the Fidanza Billet steel is 2lbs lighter then the stock 96-01 Cobra flywheels.
I will be heading overseas in January for an internship and it's time to start tying up some loose ends. First is the extra car parts.
Without time to work on the car, and since i'm going overseas in less then a year i'm going to put off any further mods to the car. I was going for a N/A C-head build. Here are the first round of parts i'm going to let go.
All prices listed are shipped. Local sale would be meet anywhere on I-85 between W-S and Greenville, SC.
03 DOHC Cobra cylinder heads. $825 shipped. ~15k miles. They have 98 Cobra cams installed which make 20+ HP on a Mach 1. Heads are in great shape i had them cleaned and inspected by KT engines in Concord, NC. They were milled from 52cc to 47cc chambers to arrive at a Compression ratio of ~10.7:1. This is a safe limit for pump gas stock bottom end n/a cobras and mach 1's.
04 Mach 1 intake manifold. $350 shipped. SOLD
04 Aviator intake manifold. $300 shipped. Was purchased for my project as phase II of a N/A C-head build up. Complete with rails, injectors, throttle body, IAC, fuel rail pressure sensor, IMRC motor, and throttle and cruise bracket.
http://www.fidanza.com/SteelFlywheels.aspx
Fidanza 8-bolt Billet Steel Flywheel. $150 shipped Has about 15,000 miles on it, but comes with a new friction insert (still in the plastic) so for all practical purposes its new. These retail for $240 i'd like to get $150 shipped. Paypal only please. Pics available tomorrow upon request. For those that dont know the Fidanza Billet steel is 2lbs lighter then the stock 96-01 Cobra flywheels.
Last edited: