Forged 4.75l Short Block 5,000 miles

[James Palanza]

Okay lets try this again and see if my photos actually stay linked in. Shows them when I preview the thread. Shows them when I edit the thread. Then poof they are gone. Including the DIRECT LINKS AS WELL.

2500$ PLUS shipping to you (probably 150 to 250 additional for shipping) engine is located near Pittsburgh PA

Details on the block:

8.8 Compression
.008 piston to deck height
stock rod length
slight stroke to 3.650
-18cc pistons
Pistons are notched for 3v

Teksid 4.6 Alum block bored 20 over

MMR 900SE Forged 4.75 Rotating Assembly
Coyote Forged Crank with 3.650 stroke
4340 MMR H-beam Rods w/ARP rod bolts
Forged Manley pistons -18cc
Total Seal file fit moly rings fit for big boost
Clevite Rod and Performance Main bearings

This was machined and put together by my local mustang shop that is very well known and good at what they do. No issues whatsoever with the block mechanically. Cylinder bores look good, check photo.

MMR advertised the assembly to be good up to 900rwhp, I had 550 going through it no issues.

This will be shipped insured and in a crate/pallet so shipping will prob be 150-200$

Will include motor mount adapters and machined stock ears for install of teksid block to motor mounts. Extra 250 if you want the ford racing oil pump and billet oil gear.

IMGS:
http://i.imgur.com/wnFrCAK.jpg

http://i.imgur.com/XXcjpGC.jpg?1

 

[James Palanza]

 

[Boosted07]

I know your add is a month old, but do you still have the block for sale?