I just was finishing up the install of my exhaust and have a question for you guys. The short pipe after the cat on the passenger side of the truck, where is your o2 sensor located? I think the bung for mine might be welded in the wrong position. It is pretty close to hitting the cross member and pointed down to the ground almost vertical but at a slight angle. Plus the o2 sensor that is part of the trucks wiring system had to be removed from its mount so the wire would fit because without moving it it was about an inch or 2 short. Thanks for any help.
? for those with JLP R exhaust
- Thread starter 2000 LiGhtNinG
- Start date
I couldn't tell you what my JLP R exhaust looks like, I had it done while it was at the shop
Mine was the same way as yours, I even brought it up to JL but I guess they never changed it. My rear O2's are deleted (removed) anyways now.
thanks fade
Ya they are supposed to be angled down not up so if they are not off and any moisture gets to them they are going to thro a code
Users who are viewing this thread
