Exedy Mach 600?

[96chargedcobra]

hi everyone,

I made a thread earlier about a slipping clutch. Well after some thought I found the exedy Mach 600. I'm not planning on doing any thing other than a pulley 2.5 pulley on the m122. Do think this clutch would last a while?
Car is a bone stock 2012 svtpp car.

The reason this one is so attractive is it comes with 280mm disc, flywheel, slave, tube, and bolts for $700

 

[SuperSoulless]

Did you end up doing it? I'm looking at purchasing the same kit

----------------------------------
2009 GT500
Black with Red Stripe Appearance Package
Flowmaster Outlaw Catback

 

[fmylife]

Not sure I would feel comfortable using that clutch unless the car stayed completely stock and didn't race with it. AM shows it will hold up to 650 ft lbs of torque (assuming at the wheels because it lists 734 @ flywheel).

I went with the McLeod RXT even though mine is only putting 530rwhp. I wanted it in case I decided to go nuts later and upgrade the SC and would hate to push the limits of a lower end clutch at that point.