Quick question.
I installed the even flow kit today while I had the Whipple out. My question - is there suppose to be a small gap between the bracket (securing the fitting to the freeze plug) and the cylinder head? I was just wondering if this is suppose to be flush because I could not get the fitting in further into the cylinder head. It is just slightly higher than the bracket. I have the new version (if that matters).
Thanks.
I installed the even flow kit today while I had the Whipple out. My question - is there suppose to be a small gap between the bracket (securing the fitting to the freeze plug) and the cylinder head? I was just wondering if this is suppose to be flush because I could not get the fitting in further into the cylinder head. It is just slightly higher than the bracket. I have the new version (if that matters).
Thanks.