*Error codes after Newly built Teksid engine install?**

[Sweet '96 Cobra]

Since installing my new built Teksid I keep getting a couple of codes coming up and have tried clearing them with my sct tuner and they eventually come back.. I've even uploaded my tune back in the car to see if that would correct it but no luck..

1st on is (P1000 obd readiness test not complete) not sure what this means?

2nd is (P0243 turbo/supercharger wastegate solenoid A tcwgs-a)????

3rd is (P2195 o2 sensor biased/stuck lean (b1/s1)). Sound like a bad o2 sensor? If so which one is it? I installed new longtubes and a new catted xpipe.. Maybe once I get my new dynotune in a couple weeks it will take care of this stuff? I'm staying out of the boost until I get my new tune and breaking the engine in delecatly.

 

[hotcobra03]

Po1000 you need to drive car to complete..


po243. I would check engine harness for damage being you replaced engine.

O2 code.b1s1 is passenger front..you can swap fronts side to side code follows o2 than its just a bad o2..code stays the same than wiring could be issue

any other codes that were there and didnt come back can br usefull...

 

[DSG2003Mach1]

^^ what he said

also the P1000 will not trip the check engine light by itself