engine build?

[Darufe]

So im currently emailing mmr about a block build.

So far im up to over 18k assembled for a complete setup from pan to intake.

5.2l promod 1500 10:1cr
Stage 3 mmr heads with titanium retainers
Stage 3 mmr turbo cams
Mmr intake
Race spec chains/guides
Dual mmr valve breathrs
Phaser eliminator
Tivct blockoffs
Plugs
Pulse ring
Crank gear
Ati balancer
Covers
Gaskets
Alloy pan
Arp everything
Assembly


I think im overkilling it a bit but at this piint I might as well overbuild and forget about it instead of having to reopen and change stuff in there.

Anything else I should need?
Any other suggestions for builders?

 

[grnenvy]

If u have it spend it. IMOP the Stage 3 heads are over kill unless your running over 20psi.
I have had great service and good luck with my MMR motor.

 

[Darufe]

Planning to run as much boost as the 6266 can push out without crapping out haha

 

[grnenvy]

Get the porting. lol I'm not sure what valve's your going with but go with solid stainless for strength. MMR has the better retainer also.

 

[Darufe]

Ya the mmr stage 3 heads come with stainless valves updraded springs and I took titanium retainers in the build. Unsure what size valves come with it though I might ask how much for the 1mm oversize if thats not already whats in there

 

[redline5.0]

I would do the boss chain tensioners too if there not in the setup somewhere. Had my engine built and a bad factory tensioner with only 8k miles and there good for higher rpm as well.