i painted my brakes this winter and left the ebrake spring connected and just slid the cable out. now when i got the brakes all back on and bled the ebrake doesnt work at all, everything is connected as far as the rear end goes but im wondering if something disconnected towards the handle in the car. its also a possibility that i had the brake engaged when i took them off, which i just read on a thread here that your supposed the disengage it. i removed it the same way last winter to do the ftbr kit and didn't have any trouble then so im stumped. the cable runs along the floorboards and goes up underneath so i cant see where it goes.
E-Brake no longer working! HELP!!!
- Thread starter SonicBeast
- Start date
One of the cables may have slipped the "y" connector in the driveshaft tunnel. Each cable routes from the brake to the center tunnel. From there, they are connected to the e-brake handle cable. You may have to drop the driveshaft to see/fix it. Good Luck.
read this
https://workspaces.acrobat.com/?d=M2nZBqooRJLaGhd*n-wj9Q
cable front
https://workspaces.acrobat.com/?d=T7fXkH2okP7OQ83CQ72oXA
cable rear
https://workspaces.acrobat.com/?d=C-G4sl7DEx7a9WbJLJdEFQ
pb testing
https://workspaces.acrobat.com/?d=tHDNMl*crjHVi9RP1Zb7*Q
https://workspaces.acrobat.com/?d=M2nZBqooRJLaGhd*n-wj9Q
cable front
https://workspaces.acrobat.com/?d=T7fXkH2okP7OQ83CQ72oXA
cable rear
https://workspaces.acrobat.com/?d=C-G4sl7DEx7a9WbJLJdEFQ
pb testing
https://workspaces.acrobat.com/?d=tHDNMl*crjHVi9RP1Zb7*Q
Last edited:
Users who are viewing this thread
