Dropping the K member for header install?

[jakhammer]

Car is finally going under the knife for the header install. I'm dropping the K member. My question is where are all of you that drop the K member supporting the car in the front? I use the K member as my jack points. If it's dropped how do I keep the car in the air to work on it?

 

[Swies]

Sorry getting old, but I believe I put mine directly behind where the rear of the K-member bolts to the body.

 

[wickedsvt2002]

I did mine off the bell housing. There's a flat spot I had a screw jack with a 2x4.

 

[SCalla1384]

Put the jacks on the frame. Right after where the k member bolts to it.

Then I put a jack with a phone book right at the edge of the bellhousing, and I bought a harbor freight engine support bar for like $80 to support the motor. The jack was there just in case.