Driving light help?
- Thread starter turbo
- Start date
I was able to change mine with the car on the ground and I didn't remove anything. I just turned the wheel all the way stuck my long thin arm up into the front bumper just had to pull back the inner fender liner a little removed bulb and installed the new one and then did the other side took about 1 minute per side. If you have big arms and or short arms you may not be able to get up in there with out removing a few screws.
I was unable to do mine through the wheel wells. (It was a very tight fit for my arms, and I don't operate well in-the-blind.)
The job was, however, SIMPLE with a set of ramps and the removal of a plastic panel held in place (behind the splitter) by 9 screws. Check out Copper&Black's post for a picture of the removed valence. (Note that removal of the driving light assemblies/reflectors is NOT required.)
The job was, however, SIMPLE with a set of ramps and the removal of a plastic panel held in place (behind the splitter) by 9 screws. Check out Copper&Black's post for a picture of the removed valence. (Note that removal of the driving light assemblies/reflectors is NOT required.)
He didn't say fog lights....
That's right, he said driving lights. Which some people call fog lights.
^^helpful. thanks:bash:
Users who are viewing this thread
