Diff Cover Brace Help

[Teviinz]

Started installing the billetflow diff cover brace yesterday and everything went well until it was time to install the 2 new rear diff cover mount bolts. Problem one is i there isnt enough room to get the bottom bolt in due to the black bracket. Problem 2 is i cant seem to get the pumpkin to line up with the rear diff mount. any help is greatly appreciated

 

[01yellercobra]

IIRC you have to slide the bolt in before putting the diff in place. I don't have any pointers for aligning it. I just wiggled it until the bolt started.

 

[Teviinz]

is there anyway to lower the back of the diff. i have the front mounting bolts removed but the rear of the diff doesnt seem to want to lower

 

[01yellercobra]

Are the half shafts installed? If not it shouldn't be hard to drop the back of it down. You might have to move it forward a little to get the needed clearance.

 

[Tractionless1]

Step 1 Sell brace cover

Step 2 Install reinforced cover.

Step 3 Never worry again.

 

[mp23]

Are the half shafts installed? If not it shouldn't be hard to drop the back of it down. You might have to move it forward a little to get the needed clearance.

This ^^