Data logging with SCT XCal2. Wired in my 9 pin analog cable after 5 days of research. Plug it into the handheld and run Livelink. I've selected the pre loaded analog equation for my Dynojet Wideband Commander which is (v*1.6)+10. O to convert the 5v signal. I would expect to see a functioning AFR guage, but instead I'm getting a a guage that gives me readings from .0000-.0004. Why is livelink giving me these guage parameters? Below I've taken snapshots of the guage, as well as snapshots of the diagrams and info that I used to set up the analog 9 pin cable. I've got the Analog 1 wire tapped into the white/yellow striped wire, and the ground from the 9 pin cable tapped into a black/white ground wire that comes off the wideband commander.
Data logging with SCT XCal2, Dynojet Wideband Commander, Livelink not accurate
- Thread starter skratpiece
- Start date
Looks like you have it right. Sounds like you need to probe around with a multimeter to verify the connections.
Users who are viewing this thread
