Home
What's new
Latest activity
Authors
Store
Latest reviews
Search products
Forums
New posts
Search forums
What's new
New posts
New listings
New products
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
Cart
Cart
Loading…
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Search titles only
By:
Menu
Log in
Register
Navigation
Install the app
Install
More options
Change style
Contact us
Close Menu
Forums
Cobra Forums
The Terminator
Driveline
DANG:Need Clutch Opinions for '03 Cobra....
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="noslo50" data-source="post: 191661" data-attributes="member: 4438"><p>Ok, </p><p>1. Took about three hours, but i have an aftermarke h-pipe, the front 02 sensors can suck to unplug with stock and pass exhaust. </p><p>2. I used a D&d motorsports kelvar disk and street strip pressure plate(they are in mm&ff).</p><p>3. yes i put over 400 miles on it as recommended, But i later found out it is the stock cable and adjuster causing the slippage and if you didn't fry yours too bad you could probably just change to and adjustable cable/quadrant and your slippage will be gone.</p><p>4. No i actually ordered a complete ford clutch/flywheel assembly and replaced the flywheel as i was told it can't be resurfaced because it is a steel insert and you can't purchase the flywheel seprately, but i could of just cleaned the old one but i had alreadt order it so i used it if yours isn't too bad you may want to just use a 3m abrasive disk(for gasket removal for clean-up).</p><p>5. Not sure on my power, no one has a dyno around me but with the clutch issue and my belt slipping i ran 11.93@116.98> Jerry</p></blockquote><p></p>
[QUOTE="noslo50, post: 191661, member: 4438"] Ok, 1. Took about three hours, but i have an aftermarke h-pipe, the front 02 sensors can suck to unplug with stock and pass exhaust. 2. I used a D&d motorsports kelvar disk and street strip pressure plate(they are in mm&ff). 3. yes i put over 400 miles on it as recommended, But i later found out it is the stock cable and adjuster causing the slippage and if you didn't fry yours too bad you could probably just change to and adjustable cable/quadrant and your slippage will be gone. 4. No i actually ordered a complete ford clutch/flywheel assembly and replaced the flywheel as i was told it can't be resurfaced because it is a steel insert and you can't purchase the flywheel seprately, but i could of just cleaned the old one but i had alreadt order it so i used it if yours isn't too bad you may want to just use a 3m abrasive disk(for gasket removal for clean-up). 5. Not sure on my power, no one has a dyno around me but with the clutch issue and my belt slipping i ran 11.93@116.98> Jerry [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Cobra Forums
The Terminator
Driveline
DANG:Need Clutch Opinions for '03 Cobra....
Top