Coupe Spring Cut and put on a vert! How to.
Hey guys. Posted some stuff in pics and videos. Figured a few vert Terminator owners might search here. 10th anniversary with 18" 10th SVE Deep Dish wheels. 245/45-18 Nitto 555's out front. 305/35-18 Nitto Drag Radials in the rear. I cut 3/4 coil off the front springs. 1/2 coil off the rear. All isolators still installed. Took about 7 or so hours with two of us farting around. Used the directions from How To Install An H & R Mustang Race Spring (1999-2004 Cobra) - Installation Instructions at AmericanMuscle.com
All directions worked well. Be a little careful on the tie rod end removal. The top of them is much softer than the tool from Autozone. Also, the smallest tool they had was a little big. Here is the link to the before and after.
Lowering Before and After - a set on Flickr
PM me if you have any questions.
:beer:
Hey guys. Posted some stuff in pics and videos. Figured a few vert Terminator owners might search here. 10th anniversary with 18" 10th SVE Deep Dish wheels. 245/45-18 Nitto 555's out front. 305/35-18 Nitto Drag Radials in the rear. I cut 3/4 coil off the front springs. 1/2 coil off the rear. All isolators still installed. Took about 7 or so hours with two of us farting around. Used the directions from How To Install An H & R Mustang Race Spring (1999-2004 Cobra) - Installation Instructions at AmericanMuscle.com
All directions worked well. Be a little careful on the tie rod end removal. The top of them is much softer than the tool from Autozone. Also, the smallest tool they had was a little big. Here is the link to the before and after.
Lowering Before and After - a set on Flickr
PM me if you have any questions.
:beer:
Last edited: