Hey folks,
Now that my '03 has been gone for quite a while, its time to get rid of my stash of misc. parts. Here is a list of what I have (all located in Chelmsford, MA):
Aftermarket parts
Front snake grille emblem
Brembo rear slotted rotors (500 miles on them)
Red powdercoated rear calipers (500 miles on them)
BBK twin-65mm TB
Supercharger belts
Kenne Bell CAI
McCleod SFI bellhousing (modified to fit longtubes)
Centerforce DFX clutch disc (26-spline)
Stoptech front brake hoses (used)
MGW large cup trim ring and headlight knob (matte silver finish)
Evans overdrive water pump pulley (slight wear)
Pro-M 95mm MAF w/adapter and flow sheet (never used) - calibrated for 72lb calibration
Front hubs w/3" studs (500 miles)
Rear tie rods with Maximum Motorsports bump steer kit
'03 Cobra Stock parts
Radiator fan (500 miles)
Power harness (connecs to battery, alternator, block, etc.) - NEW
(2) Cobra throttle bodies
Water pump (long snout)
Radiator hoses (upper, lower, middle)
Intake tube (modified for nitrous nozzles)
MAF
Misc. parts from other mustangs
3-bar spinners with "Ford" center emblems (fit any wheels with 2.5" openings)
PHP intake spacer and gasket for '01 Cobra intake
2000 Cobra R radio and antenna deletes (new)
Kenne Bell switch chip (black chip, came with blower)
Diablosport Red "switch" chip
'03 Mach1 front control arm.
No reasonable offers refused. Unreasonable offers will not be responded to.
Best,
MJ
Now that my '03 has been gone for quite a while, its time to get rid of my stash of misc. parts. Here is a list of what I have (all located in Chelmsford, MA):
Aftermarket parts
Front snake grille emblem
Brembo rear slotted rotors (500 miles on them)
Red powdercoated rear calipers (500 miles on them)
BBK twin-65mm TB
Supercharger belts
Kenne Bell CAI
McCleod SFI bellhousing (modified to fit longtubes)
Centerforce DFX clutch disc (26-spline)
Stoptech front brake hoses (used)
MGW large cup trim ring and headlight knob (matte silver finish)
Evans overdrive water pump pulley (slight wear)
Pro-M 95mm MAF w/adapter and flow sheet (never used) - calibrated for 72lb calibration
Front hubs w/3" studs (500 miles)
Rear tie rods with Maximum Motorsports bump steer kit
'03 Cobra Stock parts
Radiator fan (500 miles)
Power harness (connecs to battery, alternator, block, etc.) - NEW
(2) Cobra throttle bodies
Water pump (long snout)
Radiator hoses (upper, lower, middle)
Intake tube (modified for nitrous nozzles)
MAF
Misc. parts from other mustangs
3-bar spinners with "Ford" center emblems (fit any wheels with 2.5" openings)
PHP intake spacer and gasket for '01 Cobra intake
2000 Cobra R radio and antenna deletes (new)
Kenne Bell switch chip (black chip, came with blower)
Diablosport Red "switch" chip
'03 Mach1 front control arm.
No reasonable offers refused. Unreasonable offers will not be responded to.
Best,
MJ