Cat removal....O2 sensor clips?

[ridenfish39]

How the hell do you disconnect the O2 sensors by the transmission? I could barely get my skinny hands in there. I had no problems with the bolts, which were what I was really worried about but I could not pull the connectors out. Any tips how to disconnect them? Brute force?

 

[Ron Mexico]

you gotta push in the clips before you unplug them. good times. didn't you do a dp on your ms3?

 

[ridenfish39]

you gotta push in the clips before you unplug them. good times. didn't you do a dp on your ms3?

There's like an inch between the trans and tunnel, I can barely get my skinny hand in there. I'll push and pull harder today

 

[Ron Mexico]

feel around for the clip with your skinny hands.

 

[CshiznitzJ]

Remove the plastic clip from the transmission first then the wire can extend down and you can use both hands to un-clip the connection.

 

[5PNTSLW]

remove the plastic clip from the transmission first then the wire can extend down and you can use both hands to un-clip the connection.

+1

 

[Torchy]

remove the plastic clip from the transmission first then the wire can extend down and you can use both hands to un-clip the connection.

+2

 

[C6Grandpasport]

Remove the plastic clip from the transmission first then the wire can extend down and you can use both hands to un-clip the connection.

And in order to do this, dont you have to push up on them to unhook them.

 

[Ron Mexico]

can you post a picture of the plugs when get them out? I'm doing this too in the next month and it sounds much more complicated than my previous ms3 faggotry. at least the o2 sensors aren't cross threaded.

 

[scott_0]

Remove the plastic clip from the transmission first then the wire can extend down and you can use both hands to un-clip the connection.

yup, had to do this with my fatty hands lol