Hey Guys,
I was going to post this in the classic section, but figure I'd get more responses here...
I'm installing an '04 Mach1 engine into my 1970 Fastback. To clean it up, wiring wise, and keep it old school looking, I'm going to be running a Sullivan intake and carb. Now to do this, you have to run the MSD Mod-6 Ignition Controller to fire the coil packs. I'm also toying with the idea of running the MSD Atomic EFI, however I cannot get an answer from MSD on whether its possible.
Typically the Atomic EFI gets its ignition signal from the distributor or coil, so I'm not sure where I can get that signal without having a distributor.
Any ideas whether this would work?:read::read:
I was going to post this in the classic section, but figure I'd get more responses here...
I'm installing an '04 Mach1 engine into my 1970 Fastback. To clean it up, wiring wise, and keep it old school looking, I'm going to be running a Sullivan intake and carb. Now to do this, you have to run the MSD Mod-6 Ignition Controller to fire the coil packs. I'm also toying with the idea of running the MSD Atomic EFI, however I cannot get an answer from MSD on whether its possible.
Typically the Atomic EFI gets its ignition signal from the distributor or coil, so I'm not sure where I can get that signal without having a distributor.
Any ideas whether this would work?:read::read: